Tri colour silk pla lines?

jltk87

Hi, using tri pla red gold purple and I am getting lines. Have used two other gratkit tri silk pla and they came out fine. using bambu p1p. What could cause this issue? Thanks.

william

jltk87
Hi,
The problem seems to be related to these factors:
Retract and flow. Also, are you using AMS? If you could post some parameters for slicing, I think we'd find something

Greeting

jltk87

Hi,
Yes was using ams. Perhaps I should take it out and put it in making sure its not twisted. Standard slicing bambu parameters. 3 walls, 5% infill. I have not played with the retract settings. flow .97. attached a pic of another one printed in different colour but same settings which turned out great.
Thanks

william

jltk87 Hi,
If you didn't change the settings but got a different result.
Here are the suggestions for that:

You can check whether the color is consistent from one side. If it is inconsistent, the roll is unqualified. Normally, the color should be consistent.
When you insert the filament into the extruder, check the direction of that. Please avoid it being twisted.
Hope this will be helpful

jltk87

Checked the colour and looks inconsistent to me. Now checking the other rolls and they look fine. Not much experience with duel/tri colour so now I know to inspect them first for colour.

Thanks

william

jltk87
Hi,
That makes sense. If the color's direction is not always consistent then this variable will cause a problem.